We have had a lot of demand from customers wanting switches nozzles, heated beds etc and a host of other parts so here is our slowly increasing ever expanding parts range, we have just started to add our parts to this so bear with us more are added daily,
Please email if there is a part you require not listed... chances are we have it!
Sold out
Genuine Wanhao heater cartridges slot into the hotend to provide the heat for the nozzles to melt the filament and print. MK10 12v Heater Tube fit...
View full details
Developed by the inventor of Ninjaflex Flexible filament extruder retrofit kit for both left and right sides of a dual-extruder printer. Print ...
View full details
1 x Genuine Wanhao replacement thermocouple. These run from the Duplicator 4X/S motherboard up the loom and down onto the hotend where they are sec...
View full details
This is a replacement fan for Wanhao D4s/D4x/i3 V2.1 12Volt fan (40x40)
This is a replacement fan for Wanhao i3 Plus and Flashforge Creator Pro 24Volt fan (40x40)
Sold out
Sold out
New MK10 dual-extruder assembly replaces the MK8/9 assembly on the Duplicator 4/4X/4S. Includes 2 NEMA 17 stepper motors, 2 40mm fans, 2 fan guards...
View full details
Sold out
This Heated Bed Kit replaces the bed assembly on the Duplicator 4X/S printers. Pull out the old one and insert this new one for simple plug and pla...
View full details
Sold out
This Stepper Motor Driver with Heatsink replaces one of five drivers found on the Wanhao Mightyboard (microcontroller) of the Duplicator 4 and 4X p...
View full details
Sold out
Replacement touch panel and SD card reader for Wanhao D4x.
Sold out
A direct replacement if you have lost or broken or just want to refresh your bed leveling system. Leveling Kit will fit: Wanhao D4S/X
This main switch fits the following printers: Wanhao i3 V2.1 i3 Plus D4 D5 D6 Flashforge Creator Pro Dreamer
1 x Genuine Wanhao replacement Endstop switch. These switches are located at the end of each axis and allow the printer to know when to halt axis m...
View full details
This Z-Axis stepper motor with threaded shaft replaces the motor driving the Z-Axis up & down on the Duplicator 4X/S printers. Pull out the old...
View full details
Sold out
These are in stock in limited supply! All new Duplicator 4X printers come with this spring-loaded extruder drive block upgrade as a standard featu...
View full details
This injection-molded gantry rod mount (right side mount when facing the printer) replaces broken or cracked bearing-side rod mounts on the Duplica...
View full details
Sold out
Sold out
Sold out
Wanhao D4 Filament guide tube (all black in stock)
